Can't control remote zoom and focus
Read the lens model printed on the side of the lens first. The 2.8-10mm lens has no remote zoom or focus: you turn its rings by hand, and only the iris is remote. On the 8-48mm and 12.5-75mm lenses, remote zoom and focus need the Normal Iris Type and the lens cable connected.
How to fix it
8-48mm (Vision) or 12.5-75mm (Vision PRO) lens
- Open Camera Settings, click the Setup tab and confirm Iris Type is Normal
- Confirm the lens cable is connected: straight from the lens to the back of the camera, or from the lens to the Remote Positioner and from the positioner's other port to the camera
- Try the zoom and focus buttons again
- A plain click is the smallest step; Shift-click or Ctrl-click moves the lens in bigger steps
If only zoom stopped working (iris and focus still respond)
- Confirm the iris and focus buttons still change the image, and that Iris Type is Normal
- Bypass the Remote Positioner: plug the lens cable straight into the back of the camera. If zoom works now, the problem is likely the positioner or its cable: see Remote positioner or cable damaged
- Check the lens cable along its whole length for fraying
- If zoom still fails with the lens plugged straight into the camera, the zoom motor or a wire in the lens cable is likely at fault. Submit an RMA and send the lens in to Lynx
If zoom and focus move but the image can't be made sharp
- If the image is sharp at some distance, the adapter isn't the cause: on an 8-48mm lens the silver screws on the back have probably loosened, often after a repair or shipping
- Tighten them as shown in Image is blurry and can't focus; you don't need to send the lens back for this
- Only if nothing is sharp at any distance, check the CS-C adapter (a 5mm ring) between the lens and the camera
- 8-48mm or 12.5-75mm lens: the adapter must be installed
- 2.8-10mm lens: the adapter must not be installed
- A lens other than the 8-48mm that won't focus with the right adapter may have been knocked out of position. Check it for loose screws and tighten them (don't overtighten), or submit an RMA and send the camera in for repair
- Try Auto-Focus (FinishLynx 13.10 or later): in 2-D EasyAlign mode, hold Ctrl + Shift and click Focus Near or Focus Far. Press Esc to stop it
- With a C-mount lens, first check the AEC box and open the iris as far as you can without overexposing the image
- The Auto-Focus video shows it
For where zoom, focus and iris fit in the setup order, see Align the camera on the finish line. A lens or camera that fails these checks needs a repair.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.
Related resources
- Auto-Focus video — Video · YouTube