Lens snapped off or threads stripped

When a lens snaps off, what matters is whether the camera itself was damaged. On an EtherLynx photo-finish camera, send the camera and lens in together so Lynx can check both. On an IdentiLynx, if the broken lens threads come out cleanly and the camera is otherwise fine, you only need a new lens.

How to fix it

EtherLynx photo-finish camera (for example a Vision-series camera)

  1. This needs a repair: submit an RMA and send the camera and the lens in to Lynx together, so every issue from the fall is diagnosed
  2. Do the same if, after a fall, the lens no longer reaches a firm stop when you screw it in, or feels like it has a soft stop. The stopper on the lens mount may be damaged

IdentiLynx camera

  1. Look at the front of the camera. If the broken plastic lens threads can be removed and the camera is otherwise undamaged, you only need a replacement lens from Lynx: use the button below
  2. If the threads are stuck in the camera, or the camera itself is damaged, submit an RMA and send the camera in to Lynx for repair
  3. If the lens is still attached but the image won't focus after a knock, see Image is blurry and can't focus

Many of these breaks happen when a tripod blows over: see Tripod blows over or shifts in wind. Meet coming up? Lynx doesn't run a loaner pool, but ship the unit expedited and put the date you need it back on the RMA case: see Do you offer a loaner while my camera is repaired?.

Good to know

When fitting a lens, stop turning as soon as it reaches its stopper. Tightening past the stopper damages the lens in a way that isn't repairable.

Send it in for repair

Start an RMA. The portal walks you through what to include and where to ship it.

Submit an RMA