Tripod blows over or shifts in wind
A tripod that blows over can break the Remote Positioner motors, the lens or the camera. Weigh the tripod down more than you think you need, and set up so a little movement doesn't take the camera off the finish line.
How to fix it
Weigh the tripod down
- Use a wide-base tripod
- Tie it down with heavy sandbags or blocks, or stake it into the ground
- Put the weight on the side the wind is coming from. If the wind swirls, add weight on the opposite side too
- Use more weight than you think you need
- At venues that are often windy, consider a heavier tripod, or a metal post on a weighted wheeled base with a lower center of gravity
Keep the camera on the line
- Stand the tripod on the ground, not on a table: a table wobbles
- The recommended camera height is 7-15 feet, angled down at about 45 degrees (the manual's Camera Mounting page). The higher it is, the heavier and better weighted the tripod or pole needs to be
- Level the tripod and extend it as far as you will use it before you align. Don't assume the camera will stay aligned if the tripod's head tube is extended
- In wind or on soft ground, center the camera on the finish line rather than its front edge, so it can move a little and still stay on the white
- With a Remote Positioner, fine-tune the camera position during the event to correct for wind or tripod movement
- Alternating black and white stripes in the image mean the camera is moving in and out of alignment. It needs a more solid mounting
If it already fell
- Broken positioner posts or a positioner that won't move: Remote positioner motor damaged
- Lens broke off: Lens snapped off or threads stripped
- Damaged camera body or ports: Camera body or ports damaged
- An IdentiLynx or VeriLynx that was knocked over: Camera body or ports damaged
- A positioner that rocks, or a mounting stud or bolt that broke: Camera or positioner won't mount securely
- To re-align after the tripod has moved: Align the camera on the finish line