Remote positioner motor damaged
The two rear "legs" or "posts" under the Remote Positioner's camera plate are motors. A broken motor usually comes from a fall, and shows up as one or more movements (pan, tilt, swivel) not responding in FinishLynx.
A motor is replaced as a whole: by you with the home repair guide, or by Lynx. If nothing moves and the remote iris has stopped too, check the cable before you order anything.
How to fix it
Find out what broke
- In the Hardware Control window, try each Remote Positioner control: swivel, tilt up and down, and pan left and right. Note which ones work
- Count the broken rear posts. Each broken rear post is one motor to replace
- If a front post or another part broke instead, Lynx needs to look at it: submit an RMA
- Pan (side to side) is a separate motor inside the positioner. If pan still works, you only need motors for the broken posts; if pan doesn't work, the pan motor may need replacing too
- If a white plastic motor part lifts off the metal plate when the camera is mounted, that motor is broken at the break point and can't be repaired
- Until it's replaced, the camera's weight may keep the gear engaged, so the positioner can still work with the camera seated directly on it
- Not sure which part broke? The positioner has two external motors (the rear posts, for tilt and swivel) and one internal pan motor on the underside of the top plate. The internal one rarely breaks. Check with Lynx before ordering
If nothing moves and the remote iris has stopped too
- Suspect the short gray cable between the positioner and the camera rather than the motors
- Unplug the lens cable from the positioner and plug it straight into the Remote Control port on the back of the camera
- If the iris works now, the positioner cable (or the positioner's pass-through) is the problem, not a motor. See Remote positioner or cable damaged
- If the iris still doesn't respond with the lens plugged straight into the camera, the camera's Remote Control port is the more likely fault
- Put the same positioner and lens on another camera if you have one. If everything works there, the camera needs a repair: submit an RMA. See Can't control remote iris
Replace the motor yourself
- Request replacement motors from Lynx with the button below, saying which posts broke and whether pan still works
- Replace them by following the Remote Positioner Motor Home Repair Guide
- Tools: 1/4" and 3/16" socket drivers and a medium Phillips screwdriver. Some older positioners need a 5/16" socket driver
- Move the stand from each old motor onto its new motor, fit the new motor with its wires pointing inward, and plug each motor into the board socket with its label (right, left, pan)
- Replacing only the pan motor? Skip steps 5-6 and 8 of the guide
- If a new motor doesn't fit your positioner, see Replacement motor doesn't fit
Or send it in
Submit an RMA and send the Remote Positioner in to Lynx for repair. If the camera fell with it, add the positioner to the camera's repair request so both come back together: see Camera body or ports damaged.
To keep it from happening again, see Tripod blows over or shifts in wind.
Good to know
Glue doesn't make a lasting repair on a broken motor: replace it. Don't pick the positioner up with the camera on it, and carry it in its case.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.
Related resources
- Remote Positioner Motor Home Repair Guide — Guide · PDF