Camera body or ports damaged
A camera that has been physically damaged, typically from a fall or impact, needs a repair: submit an RMA and send it in to Lynx. Common damage is a bent or broken port or pin, a bent front plate, or a lens that broke off when the camera landed on its front.
How to fix it
Check these before you ship
- Ethernet plug won't click in: look at the plastic latch at the top of the RJ45 port on the camera. If the latch is broken, the port needs repair. Submit an RMA rather than holding the cable in with tape
- The remote positioner was damaged in the same fall: add it to the same RMA as the camera. Motors can be on backorder, so sending it with the camera saves a second wait. For a motor alone, see Remote positioner motor damaged
- The lens broke off or the mount is dented: include the lens on the RMA. See Lens snapped off or threads stripped
- The front plate is bent, or the camera won't boot after a fall: a bent front plate can damage the board mounted behind it. The camera may stop booting or show the error lights described in Error 129
- Worth one try: remove the 4 screws on the outer corners of the front plate, refit the plate and tighten the screws, then boot again. If it still won't boot, submit an RMA and send it in
- It stopped booting right after a lens change: the lens itself is unlikely to be the cause. Check the BOOT light and follow the matching entry under FinishLynx not finding camera
What to ship together after a fall, and what happens once the request is in, is on the Returns Portal page.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.