Device can't join or drops out

A device joins the AirLynx by finding the Lynx SSID and having a static IP in the same 192.168.0.3x range as the access point. If it can't join, check that the access point is up on the wired side first, then the device's IP, then the wireless name.

Drop-outs usually come from other wireless traffic or a power saving setting on a device. A bridge that never lights on the camera is a different problem: the camera's USB port.

How to fix it

Can't join

  1. Ping the access point from one of the computers on the wired network. If the ping fails, recheck the gateway cabling in Setting up the wireless link.
  2. Check the IP address of the FieldLynx device. It needs its own static IP in the 192.168.0.3x range, not shared with the access point or another device.
  3. Search for the Lynx SSID with the device's wireless card. The name is on the access point label.
  4. Connect to the Lynx network.
  5. For a wireless camera, confirm the SSID on the camera's WLAN tab matches the SSID set in the access point. Make sure the SSID is different from any other wireless network nearby.
  6. For a Vision camera's external wireless bridge, make sure the bridge is set to join the access point on your timing network, not the school's or facility's Wi-Fi.

External wireless bridge gets no power from the camera

  1. Plug the bridge into the camera's USB port and wait about 30 seconds. Blue and/or green lights should show inside it. They can be hard to see in bright sun.
  2. If there are no lights, try the camera's other USB port.
  3. The Vision camera's USB ports can power the bridge, even though the bridge is rated for USB 3.0 and the camera's ports are USB 2.0.
  4. The External Wireless Bridge Quick Start Guide ends with troubleshooting notes for a common disconnect issue.
  5. If the bridge works when plugged into a laptop but never lights on either camera port, the camera's USB port isn't putting out power. This needs a repair: submit an RMA and send the camera and the bridge in to Lynx.

Drops out or unreliable

  • Make sure all other devices on the wireless network have their Power Saving Protocol turned off.
  • Make sure no other wireless device can get onto the network the camera is on.
  • If other wired EtherLynx cameras are on the FinishLynx network, turn them on before the wireless camera.
  • A Vision-series camera that loses connectivity on a poor quality network such as Wi-Fi may vanish from the Hardware Control window. Go to Help | Find Cameras... to see it, select it and click Restart. See Find Cameras in the manual.
  • A camera that drops on the wire as well as wirelessly points to a different problem. See Camera dropping randomly.

Good to know

If the access point came from another supplier, keep its manual handy. Lynx may not know it.

Send it in for repair

Start an RMA. The portal walks you through what to include and where to ship it.

Submit an RMA

Related resources