Setting up the wireless link
The AirLynx Gateway is an access point with an amplified antenna that puts your wired FinishLynx network on the air, so FieldLynx tablets or a wireless camera can join it. The access point comes set to an IP address in the 192.168.0.3x range with the SSID Lynx, both printed on its label.
Most setup problems come from a cable on the wrong connector, so follow the hookup order below or the diagram in the AirLynx Quick Start Guide.
How to fix it
How the wireless link fits together
- The access point is wired into the timing network. Wireless devices (a camera's wireless bridge, a FieldLynx laptop or tablet) join the access point's Wi-Fi, and that puts them on the timing network.
- The FinishLynx computer stays on its wired connection with its normal static IP and doesn't join the Wi-Fi. Adding an access point doesn't affect it.
- An AirLynx from Lynx comes pre-configured. You can use your own access point instead, but you have to configure it yourself.
- Don't join a camera's wireless bridge to the school's or facility's general Wi-Fi. See School or Managed Network.
- An IdentiLynx can't connect through a SeriaLynx, so it can't reach the timing room that way. Run the IdentiLynx on a network cable to the timing network's switch.
Connect the gateway
- Plug an Ethernet cable from your Ethernet switch to the PoE Injector's Lan connector.
- Plug an Ethernet cable from the PoE Injector's PoE connector to the Access Point's PoE connector, then plug in the PoE Injector power supply. Attach one antenna to the access point.
- Connect the Access Point Pigtail (the short thin cable) from the open antenna port on the access point to the DC Injector connector labeled To AP.
- Connect one end of the 50-foot Antenna Cable to the Amplifier connector labeled To Antenna.
- Connect the other end of the Antenna Cable to the Antenna.
- Plug the Power Supply into the DC Injector.
Join devices to it
- Read the IP address and SSID from the access point's label. The SSID is normally Lynx and the IP is in the 192.168.0.3x range.
- Give each FieldLynx unit its own static IP address in the same range as the access point.
- Search for the Lynx network with the device's wireless card and connect.
- For an EtherLynx PRO or Fusion camera with the internal wireless option: turn the camera on wired, open Camera Settings from the Hardware Control window, click the WLAN tab, set Mode to Access Point and SSID to match the access point, click Ok, unplug the Ethernet cable and restart the camera.
- The WLAN settings are in the manual under Additional EtherLynx Features.
- For an EtherLynx Vision-series camera, use the external wireless bridge, configured to join the access point's Wi-Fi. See the External Wireless Bridge Quick Start Guide.
- If a device will not join or keeps dropping, see Device can't join or drops out.
Good to know
Lynx strongly recommends an access point with an amplified antenna connected to the FinishLynx network by Ethernet cable, rather than a camera in ad hoc mode.
Related resources
- AirLynx Quick Start Guide — Guide · PDF
- External Wireless Bridge — Link