School or Managed Network
Cameras that work at home but not at a venue are almost always being blocked by the venue's network: a firewall, a policy on the managed network, or Wi-Fi getting in the way of the camera boot. You don't have to turn the firewall off; allow FinishLynx through it, or have IT open the two ports.
The best setup is a dedicated, isolated network for the Lynx equipment (cameras, FinishLynx computer, displays) with static IP addresses, kept apart from the school's infrastructure. At a permanent venue, ask IT for a separate VLAN or physical network for the timing system.
How to fix it
Check the Camera Network setting
- In FinishLynx, open the Camera Network list in File | Options | General. It only shows addresses the computer's network adapters already have; it can't be typed into.
- If the wired adapter's address isn't there, give the Ethernet adapter a static IP address in Windows first (192.168.0.5 is the Lynx recommendation), as in the Windows 11 networking guide.
- Choose that address in the list and restart FinishLynx.
Wi-Fi on the timing computer
- Turn Wi-Fi off while the cameras boot.
- After they have loaded, you can use Wi-Fi to reach the secretary's area or the internet if it is on a different subnet from the camera network, with Camera Network in File | Options | General set to the wired adapter's address.
- Lynx recommends keeping Wi-Fi off on timing laptops if possible, and doing internet work (live results, meet management) on a separate computer.
- A laptop with Wi-Fi, a dock or a second adapter can also be pinned to one adapter: see the Other Settings card.
Allow FinishLynx through the firewall
- Open Windows Security | Firewall & network protection | Allow an app through firewall and click Change settings.
- Check the box to the left of Lynx and both the Private and Public columns.
- If Lynx isn't listed, click Allow another app..., browse to
C:\Lynx\Lynx.exeand check the same boxes.
- If Lynx isn't listed, click Allow another app..., browse to
- If Lynx.exe is only allowed outbound, add an inbound rule for it as well.
- With Avast or another third-party firewall, set the camera network as trusted. Allowing Lynx.exe isn't enough if it treats that network as public or untrusted.
If the system must share the school's network
- Ask the IT department to open UDP port 45780, used to boot cameras on the network.
- And UDP port 41925, used for camera communication once booted.
- These are the only two ports FinishLynx uses to find and talk to cameras. If either is blocked, cameras fail to appear in FinishLynx or drop off unexpectedly.
- On a slow managed network a camera can get its address and still time out before FinishLynx hears back; see the Other Settings card for the boot wait time.
- For everything else IT should set up on a timing computer, see Computer and IT readiness checklist.
Wireless devices and the school Wi-Fi
- Don't connect a wireless camera bridge or other Lynx wireless device to the school's general Wi-Fi. It may or may not work: it needs the FinishLynx computer wired to the facility network and the facility Wi-Fi not blocking the traffic, and latency and lost packets are a risk.
- Instead, wire an access point into the timing network and join the wireless devices to it. The FinishLynx computer stays wired and isn't affected. See Setting up the wireless link.
If the cameras still don't connect after these changes, there may be more network policies for the IT department to address, and Lynx can work through them with you.
Talk to Lynx Support
Tell the team what you’re seeing and what you’ve already tried. They’ll follow up by email or phone.
Related resources
- Windows 11 networking guide — Guide · PDF