Initial connection
ResulTV-VDM runs on your own Windows computer. It is pre-configured to receive video display data on port 1024, and FinishLynx connects to that computer's IP address. Work through these in order.
How to fix it
Check the license dongle
- The green USB hardware dongle has to stay in the computer the whole time; without it ResulTV-VDM is disabled. If ResulTV-VDM won't run or behaves as though unlicensed, check the dongle is seated in a USB port first.
- Use the dongle that came with your display. It is locked to that display's resolution.
- If you are installing, follow the ResulTV-VDM QSG: enter the ResulTV-VDM license number when prompted, choose KEYLOK 2 (USB w/Driver) and Standalone in the Security Key Installation dialog, and keep the dongle unplugged until that step finishes. Both the license number and the dongle come from Lynx.
- A serial that is refused, or a second dongle that only gives demo mode, is covered in License, dongle and serial number.
Connect the display (HDMI)
- Connect an HDMI cable from the ResulTV-VDM computer to the LED display's video sending unit. A third-party LED wall takes the same HDMI into its video processor.
- Confirm the display is powered on and ResulTV-VDM is open on the computer.
- For a Lynx 360 Display, go to File | Options… | General, select the Video-360 (single) or Video-360 (double) profile and restart ResulTV-VDM.
Confirm ResulTV-VDM is receiving
- Start ResulTV-VDM by double-clicking the ResulTV-VDM shortcut. It is pre-configured to receive on port 1024.
- Note the IP address of the ResulTV-VDM computer; you need it in the sending software. Run
ipconfigfrom a Command Prompt and use the IPv4 address.
Set up FinishLynx to send data
- In FinishLynx go to Scoreboard | Options… and click New to create a new scoreboard source.
- Set Script to ResulTV_Video_1line.lss.
- Set Serial Port to Network (connect), Port to 1024, and the IP Address to the ResulTV-VDM computer's address.
- Set Running Time to Normal.
- Set Results to Auto and Size to 1, check Always Send Place, then click OK.
- Close and restart FinishLynx.
- FieldLynx and LynxPad also send through the ResulTV-Video scripts on Network (connect), port 1024, to the ResulTV-VDM computer's IP address. See Output options.
If data still isn't arriving, check the firewall
- On the ResulTV-VDM computer, make sure Windows Firewall (or any third-party firewall or antivirus) allows inbound traffic on port 1024. The allow-an-app steps are in FinishLynx connection.
- Confirm both computers are on the same network and subnet, and that the IP address entered in the sending software matches the ResulTV-VDM computer exactly.
The installer is on the Software page.
Related resources
- ResulTV-VDM QSG — Guide · PDF