Is my total station supported

A total station or EDM works with FieldLynx or FieldLynx Lite only if it speaks the same serial protocol as one of the models in the FieldLynx laser list. FieldLynx sends the measure commands and reads the distance back, so a device that isn't on that list can't talk to it, however good a survey instrument it is.

How to fix it

Check the list

  1. Open FieldLynx or FieldLynx Lite and go to Options | Preferences, LaserLynx tab
  2. Open the Laser drop-down. If your make and model is listed, select it and set the Serial port and serial parameters to match the device
    1. The Mato MTS-602R that ships with LaserLynx uses 9600-8-None-1, Flow Control None
  3. If it isn't listed, it isn't supported as-is. Known examples: the Topcon GM55 and GPT3107N don't work with FieldLynx
  4. If you have the device's serial communication protocol document, Lynx can sometimes add a device, with no promise or timeline. Use the button below

How FieldLynx turns a reading into a mark

  • Throws: during setup you take reference measurements (the circle radius, and the sighting unit to the circle center). For each throw the unit measures to the point of impact and FieldLynx calculates the distance from the circle
  • Horizontal jumps: you measure from the sighting unit to the near and far edge of each take-off board, and FieldLynx works out the board offsets. For each jump the unit measures to the landing mark and FieldLynx calculates the jump distance
  • None of this runs on the instrument, which is why a total station on its own can't give you a legal mark. See LaserLynx basics
  • From FieldLynx the mark goes on to a field scoreboard or display through the Scoreboard tab: see Scoreboard plug-in and settings

Measuring without FieldLynx (one-off only)

  1. On the Mato MTS-600 series, use Missing Line Measurement (MLM) in the instrument's Program menu (section 9.3 of the Mato manual)
  2. Sight the target held at the circle center and measure, then sight the landing mark and measure again
  3. The screen shows the horizontal distance between the two points. Subtract the circle radius yourself
    1. This is slow and easy to get wrong across a full event. FieldLynx calibrates the circle once and calculates every mark automatically

Connecting the instrument to the computer

  • FieldLynx and FieldLynx Lite only need a Windows computer or tablet, plus a serial port or a USB port for a USB-to-serial adapter (and the same for a wind gauge)
  • A serial-to-Ethernet adapter such as a SeriaLynx also works, as long as its port is set to the instrument's serial settings (9600-8-None-1 for the MTS-602R)
  • If your meet runs on Athletic.net, FieldLynx Lite can run on the same laptop as the AthleticFIELD app, and you enter the marks there. Some total stations can also connect directly to AthleticFIELD: see The AthleticFIELD Expansion Module
  • If a listed device is connected but gives no measurement, work through LaserLynx no measurement or overtilt

Repairs

  • Lynx can't repair a laser or total station it didn't supply. A metrology or survey-equipment service company that works on total stations is the route for a broken screen or a unit that won't power on
  • A Lynx-supplied LaserLynx unit that needs a repair goes in to Lynx like any other Lynx item: submit an RMA

Setup and the control measurement are in the LaserLynx quick start guide and the LaserLynx setup video.

If your device isn't on the list and you have its protocol document, use the button below.

Talk to Lynx Support

Tell the team what you’re seeing and what you’ve already tried. They’ll follow up by email or phone.

Contact Support

Related resources