LaserLynx no measurement or overtilt

When FieldLynx can't get a measurement, it is almost always the serial link between the laptop and the sighting unit, or the unit not being level. Work through the link first, then the levels.

How to fix it

Check the serial link

  1. If you use a USB-to-serial adapter, install its driver. The FTDI and ATEN drivers are in the Drivers section of the Software page
    1. The COM port appearing in Windows only means the computer sees the adapter, not the total station
  2. Open Device Manager | Ports (COM & LPT) and note the COM number the adapter shows. Unplug and replug it if you aren't sure which one it is
  3. In FieldLynx go to Options | Preferences, LaserLynx tab. Set Laser to your model and Serial to that COM number
    1. Check the serial parameters match the device (Mato MTS-602R: 9600-8-None-1, Flow Control None)
  4. Click OK, then close and reopen FieldLynx. The LaserLynx setup only takes effect after a restart
  5. On the total station itself, only level it, power it on and aim it at the prism. Don't change modes or settings on the device: FieldLynx sends every command
  6. When FieldLynx measures you should see a Connecting pop-up and hear the unit click
  7. In full FieldLynx, the LaserLynx plug-in must match the program: FieldLynx 1.96 needs LaserLynx plug-in 1.22 or later. See Scoreboard plug-in and settings

If it reports overtilt

  1. Center the bubble in the round level with the precision level adjusters, then center every cylindrical level too
  2. Swing the unit toward the landing sector. The bubbles should stay centered; if they don't, level again
  3. Keep the prism on the ground when measuring, with the reflector facing the laser aperture and the pole held still and upright
    1. The target pole is inverted so the prism touches the ground, both for the control measurement at the circle center and for every throw. Don't flip it to put the prism on top
  4. If the unit keeps reporting overtilt after you level it before every throw, it needs a repair: submit an RMA and send it in to Lynx

Confirm with a test measurement

  1. Have the marker hold the target pole at a point you have measured with a steel tape
  2. Click Test Measurement in Event Setup and compare the two distances

Full setup, leveling and the control measurement are in the LaserLynx quick start guide and the LaserLynx setup video. Which devices work is under Is my total station supported.

Battery very hot, or not holding a charge

The LaserLynx battery is a Mato part. Ask Lynx sales for the current replacement battery through Get a Quote on finishlynx.com.

Good to know

Don't keep charging a battery that gets hot.

Send it in for repair

Start an RMA. The portal walks you through what to include and where to ship it.

Submit an RMA

Related resources