Run FinishLynx without a camera

Yes. FinishLynx runs without a camera when it isn't looking for one. This is how an evaluate computer works, and it is handy for practice, for testing scoreboards and for driving a display board at a 5K or cross country meet.

How to fix it

Set it up

  1. Open FinishLynx and click File | Options, General tab
  2. Set Hardware Type to None (see General options in the manual)
  3. On the LapTime tab, click New to add a LapTime device. You don't need to change any of its settings
  4. Click OK and restart FinishLynx

What works without a camera

  • Opening, evaluating and saving events and images captured elsewhere, as on an evaluate computer: see Capture-and-read FinishLynx setup
  • Scoreboard output, for testing a board or driving a display
  • A running time from a manual start: set the start sensor to None, then click Event | Manual Start and press the Space Bar at the gun. Manual starts are only accurate to 1/10 of a second

Good to know

Set Hardware Type back to Ethernet before you time with the camera again.