Cross-country workflow

Cross country runs like a track meet in FinishLynx, except that finishers are identified by bib number (ID) instead of lane. Chips are optional: with a chip system, the chip reads can fill in the times while you can still tag athletes from the image.

How to fix it

Set up the cameras and identify by bib

  1. Set up and load the cameras as you would for a track meet: the EtherLynx line-scan camera and the IdentiLynx front camera, with start and capture as usual.
  2. On the line-scan camera, click Camera Settings | Setup tab and set Identify by to ID (not Lanes).
    • For an event that is already open or saved, click the identification button just above the image until it shows ID. That changes only that event.
  3. Make sure bib numbers come through in the ID column of the start list, not the lane column. If Identify by is set to Lanes, bibs are treated as lane numbers.
  4. There is no limit on entries per race. You can leave events unseeded and open the empty event from File | Goto Event | Load Schedule; FinishLynx adds athletes as you identify them by ID, using the names in lynx.ppl from your meet software.

Evaluate without chips

  1. Click each finisher on the leading edge of the torso, type their bib number in the ID box and press Enter, just as on the track.
  2. Use the front-facing IdentiLynx video camera to read chest bibs, which are hard to see from the side.

With chips: make the chip time the official time

By default, the Time field fills in only when you evaluate the image. Two hidden settings let the chip read fill it while you can still tag athletes from the image.

  1. Hold Ctrl+Shift and click File | Options… to open the hidden settings.
  2. Set LapTime\FillInTime to 2. The default, 1, fills the time from the decoder only when Hardware Type is None; with 2, the chip read fills the Time field even with the camera loaded.
  3. Set LapTime\TotalLaps to 1 for a finish-only decoder, or to the number of split points if you have mats on the course.
    • Make sure each event has the right number of laps before any chip data arrives for it. The chip time card on the FinishLynx Other Settings page explains both settings.
  4. Set up your decoder with Decoder settings. For Trident, follow the IPICO video with port 10001 and Final Split set to LapTime.

Race-day checks

  • The status bar shows LapTime: Received #, not NOT CONNECTED.
  • MYLAPS with no GPS on the camera: trigger a gunshot on the decoder at the start of every race.
  • MYLAPS: clear old data from the decoder before the meet and start a new file for each race. In Timing & Scoring, click the ? next to the decoder and load all data, so it starts again from File 1.
  • If every bib number matches its chip number (ignoring leading zeros), you don't need a chip map file.
  • Before the first race, create a test event, set its Laps to 1, give it a manual start (Event | Manual Start, then the Space Bar) and pass a chip over the mat. The ID column should show the bib number (not the chip code) with a time.
  • Turn on line labels (Alt-N) so you can scroll the image and confirm every chip was received.
  • For team scores on a display, see Connection to FinishLynx.

Watch XC Triad: FinishLynx, IdentiLynx, & RFID for Cross Country and LapTime Operations: Total Laps. For missed or extra splits on a course with split mats, see Split problems.