Times not assigning to lanes
If evaluating the image adds blank lines to the Results instead of giving the times to the athletes already there, the Identify By setting is wrong.
With Identify By set to Nothing, every evaluation creates a new result line, so typing a lane or hip number adds an unnamed athlete instead of timing the runner.
How to fix it
Set Identify By
- Open Camera Settings | Setup tab
- Set Identify by to Lanes. New events use this setting
- For cross country, or any race where you identify finishers by bib number, set it to ID instead: see Cross-country workflow
- For a race that is already open or saved, click the identification button (the ID Mode icon) just above the image, to the right of the small text box, until it shows Lanes
- It shows a circle with a line through it when set to Nothing
- The change applies to that event only; new events use the Camera Settings default
Record a time by lane
- Click the image to place the hash line on the finisher's torso
- Type the athlete's lane number in the ID box next to the finish time
- Press Enter. The time goes to the athlete in that lane
If lanes can't be set up at all, or your lane dividers keep moving back, see Settings reset every race. The Identification Method page of the manual describes each option.