Settings reset every race
Camera and lane changes you make inside an open event stay with that event only. To have every new event start with your settings, save one event as a template, and set the lane dividers with no event open.
How to fix it
Save an event template
- Set up one event the way you want it (zoom, brightness, window layout) and save it.
- Click Event | Options… and, on the Event tab, set Event Template to Use Default.
- Click the Default Template Browse… button, select the event you saved, click Open, then OK.
- New events now start with those settings. To pick a different template for one event, hold Shift while you choose New or a schedule command.
Good to know
Loading a template overwrites any camera changes you made during the meet.
Set the lane dividers
- Close all open events.
- In the Hardware Control window, turn on alignment, then click (or right-click) the lane bar on the left side of the image and choose Lanes, not Enhance.
- Drag the small arrows one at a time until each lane divider lines up with a lane line.
Check these
- Lane dividers set inside an open event apply only to that event.
- With the Default Template field blank, new events take their layout from the Hardware Control window. With a template set, they take it from the template event, so a template can override your lane changes.
- This isn't a Windows permissions problem: if other settings such as the window layout save, lane changes will too once they are made with no event open.
If lanes can't be set at all
- Click Camera Settings | Setup tab and check that the number of Lanes is set.
- If the lane bar shows enhanced regions (a capital E) instead of lanes, click (or right-click) the bar and choose Lanes.
Related
- To assign times by lane once the lanes are set, see Times not assigning to lanes.
- If a new event says "no cameras enabled", that is the camera's Capture setting, not a template: see "No cameras enabled" when capturing.
- The full steps are in Templates and Advanced evaluation functions in the manual.