Times are in TOD
Results show time of day (TOD) instead of elapsed time when the event has no start: the start signal was never received, or the event was re-armed and the start became separated from it.
Times in 24-hour (military) format, race times of about 16 hours, or a negative time after clicking Arm Event have the same cause and the same fix.
How to fix it
If the event is still open
- Select the right start in the list of start signals near the top of the window
- Click the Add Selected Start icon to the right of it, which applies the selected start to the selected event
If the event was saved and reopened
- Click Event | Select Start…. The list shows the start signals closest to that event (the five most recent when it was created or reloaded, plus any received while it was open)
- Click the first one and click OK
- Check the times in the Results. If they're wrong, try the other starts in the list
- If none of them gives correct times, FinishLynx never received the start
If FinishLynx never received the start
- You can still add a start afterward: the Repeat button on a RadioLynx transmitter, a TOD start if you know when the gun fired, or an Image Start from one athlete's known time. See Recover a race after a missed start
- Without any start, FinishLynx can only show time of day (known limitation)
- If a "start sensors failed to arm" message appears when you open events, fix that first: "All start sensors failed to arm"
If you want time of day on purpose
- The image and the Results show time of day only when the event has no start
- To get time of day everywhere (image, results, scoreboard) while the running time and everything else that needs a start keeps working, click Event | TOD start… and enter zero
- An event that already has a start can't have it removed, only changed. To show its results as time of day, click Results | Filters…, check Offset, and enter the time of day of the start signal. Each result then shows its elapsed time plus the start time
- With chip timing, removing the Start Mask in LapTime | Options… brings transponder reads in as time of day when there is no start. The LapTime Info Time Mode setting switches the LapTime data to time of day
See Apply Starts and Time of Day Starts in the manual.