Weird characters and letters

Garbled text on a ResulTV display has two common causes: the source script in ResulTV does not match the program sending the data, or the two programs use different character sets (Code Set). Data in the wrong fields points to the script; unreadable characters point to the Code Set.

If the display turned to gibberish partway through a meet, start with how many copies of FinishLynx are sending to it.

How to fix it

If the display turns to gibberish partway through a meet

  1. Close every other copy of FinishLynx that sends scoreboard output to this ResulTV, on this computer and on any other computer on the network, so only one copy is sending.
  2. Then check the source script and the Code Set below.
  3. Don't swap the scan converter or video cable, and don't expect a reboot to help: the garbled text is in the data ResulTV receives, not in the video signal.

If data lands in the wrong fields

  1. In ResulTV, go to File | Options | Sources tab.
  2. Check the source script matches the program sending:
    • FinishLynx with the legacy ResulTV.lss script: FinishLynx.rss
    • FieldLynx with the legacy scripts: FieldLynx.rss
    • FinishLynx or FieldLynx with a ResulTV_Video script (the ResulTV-Video method): VideoDisplay.rss
  3. A field showing raw script text such as "Command=Layout…" means ResulTV is not reading the commands the FinishLynx script sends: a sign of the wrong source script. FinishLynx scripts that switch layouts (for example a wind script that changes screens) need FinishLynx.rss, not FieldLynx.rss.

If the characters themselves are garbled

  1. In FinishLynx, go to Scoreboard | Options and note the Code Set on your ResulTV scoreboard.
  2. In ResulTV, check the Code Set on the matching source.
  3. Set both to the same value: both Single Byte or both Unicode.

More than one scoreboard output sending to ResulTV can also make layouts flash. See Flashing screens. The script pairs are listed in the manual's Data source basics.