No wind readings in FinishLynx

When the gauge is connected but no reading appears, the cause is usually power to the gauge, a cable connection, the Wind tab settings or a damaged 200 foot cable. The red light next to the XLR port tells you where to start: it blinks when the gauge has power.

How to fix it

Check the light on the gauge

  1. If the red light is blinking, the gauge has power: go on to the Wind tab settings.
  2. If it isn't blinking, check the cable connections.
    • On a Connection Box, the red and black plugs go in the 12 V ports, not a photo-eye port.
  3. Check the camera's 12 V ports with a voltmeter: they should read 12 V.
  4. No light at all, or a solid light: see No light, solid red light or stopped after a fall.

Check the Wind tab settings

  1. Go to File | Options, Wind tab.
  2. Set Wind Module to Lynx and Serial Port to <camera name> (Body).
    • On a Connection Box, the port is <camera name> (C-Box).
  3. Check 9600 baud, 8 data bits, no parity and 1 stop bit, then close and reopen FinishLynx.
  4. Start a test race. The reading appears after about 10 seconds.

Rule out the 200 foot cable

  1. Connect the gauge with a shorter cable run.
  2. If readings appear now, the long XLR cable is likely damaged.

If readings only come with a battery on the gauge

The gauge isn't getting enough power from the camera.

  1. Test the camera's 12 V output while the camera is running: measure across the red and black ports with a voltmeter.
    • Or plug in a RadioLynx receiver that takes its power from the camera (the cable with the serial connector and red pin). It draws power the same way the gauge does.
  2. If the camera powers the receiver but not the gauge, the fault is in the gauge.
  3. That needs a repair: submit an RMA and send the gauge in to Lynx. If you connect it through a SeriaLynx, send that too so the whole setup is tested together.

For a gauge on a SeriaLynx, the port settings and the separate power supply it needs are in Initial connection.

Send it in for repair

Start an RMA. The portal walks you through what to include and where to ship it.

Submit an RMA