Automatic capture not working
Automatic capture needs three things: the Automatic Capture (ACM) plug-in installed and licensed on this computer, Capture Method set to Automatic for each camera, and capture switched on in the event window.
How to fix it
Install the plug-in (new computer or first setup)
- Download the FinishLynx Automatic Capture Plugin from the Plugins section of the Software page
- Close FinishLynx, run the installer and enter your Automatic Capture serial number when it asks
- On the serial sheet it may be labeled "Virtual Photo Beam Unit"
- Plug-in serials carry over when you install a new FinishLynx version into the same folder; on a new computer, enter it again
- Open FinishLynx and check that Help | About lists the Automatic Capture plug-in with its serial number
Set each camera to Automatic
- From the Hardware Control window, open Camera Settings and click the Capture tab
- Set Capture Method to Automatic
- Uncheck Manual
- Click OK
- Repeat for each camera. Camera settings don't carry over to a new computer, so set them again there
Turn capture on in the event window
- Click the capture icon so it shows the enabled state. The icon toggles between disabled and enabled
- Alt-T also toggles capture
Check these
- If Capture Method is grayed out or Automatic isn't offered, the plug-in isn't installed or licensed on this computer. See Option grayed out or missing
- A "no cameras enabled" message means no camera is set to capture: in the Hardware Control window, right-click or double-click the camera's Capture column to set it to Yes. See "No cameras enabled" when capturing
- If capture never stops once it's on, see Camera captures nonstop
- Under indoor lighting or at dusk, automatic capture can miss athletes because the image is too dark for it to trigger. Fix the image first: Too dark at dusk or under lights
- To have capture on as soon as an event loads, so nothing is missed when the gun goes, see Never miss a start because capture was off
The Automatic Capture page of the Online Manual covers the detection settings (Object Threshold, active area, Min Time), and the ACM plug-in video shows the setup.
Related resources
- ACM plug-in video — Video · YouTube