Too dark at dusk or under lights
At dusk or under stadium lights the camera simply has less light to work with, and Auto Iris can only open the iris as far as it goes. Let FinishLynx follow the light first, then add light at the finish line, and only then trade a little frame rate for brightness.
How to fix it
Let FinishLynx follow the light
- On the Camera Settings | Parameters tab, set Gain Method to AGC and check Auto Iris
- Auto Iris needs a remote-control lens connected to the camera back or through a Remote Positioner
- Keep AGC unless it doesn't give the result you want; manual gain is only for that case
- If the iris doesn't open, check the Iris Type matches your lens: see Image is fully dark or black
- If you turned Auto Iris off earlier, turn it back on without restarting FinishLynx: check Auto Iris again, or click the Auto Iris icon in the image toolbar
- Manual iris lens: turn the iris ring toward the smaller f-numbers (for example from f8 toward f2.8). The smaller the number, the more light reaches the sensor
- If the image is still too dark, raise the AGC Brightness. A Maximum Gain of 150 suits most conditions and can go up to 250 in extreme low light, but high gain adds noise to the image
Add light and contrast at the finish line
- Aim a spotlight, or a second spotlight, at the finish line. Incandescent quartz-tungsten-halogen lamps, or metal halide lamps overshadowed with halogen, light the line without putting bars on the image
- Stand a white board in line with the finish line, just beyond the last lane, so the far lanes have a white background
Lower the frame rate slightly
- Type a slightly lower value in the camera's Rate field in the Hardware Control window and press Enter
- A lower frame rate gives the sensor more time to expose each image, so the picture gets brighter. It isn't ideal for sprints, so lower it only a little
Use LuxBoost if your camera has it
- LuxBoost is an option on EtherLynx Vision-series cameras that amplifies the available light. It is most useful once the gain climbs above 150 and the image gets noisy
- To see whether your camera has it, open the LuxBoost drop-down on the Camera Settings | Parameters tab and look for levels above 1
- Check Auto LuxBoost so FinishLynx picks the LuxBoost level from the current gain. It only changes the level while capture and alignment are off
Check these
- Regular dark vertical bars under stadium or indoor lights come from the artificial light. On cameras with Phased Light Compensation, set Phased Light Comp. to On on the Camera Settings | Setup tab
- After capture, Enhance can help separate athletes from the background, but it can't rescue an image that is far too dark
Double Mode, LuxBoost and gain do different things
- Double Mode (EtherLynx Vision PRO 6K and 20K) collects more light, so the camera needs half the light for the same frame rate. On the Camera Settings | Parameters tab set Pixel Mode to Zoom 200%, then check Double
- LuxBoost and gain amplify the signal the camera already has, and they amplify the noise with it. LuxBoost takes over where gain gets noisy, above about 150
For more on LuxBoost, see the manual's Gain Control Tools page and the Auto LuxBoost video. For starting values of each setting, see Starting camera settings.
If the problem is the low sun in front of the camera, see Glare from the sun. To get results onto a video board, see Results on a video board or TV.