Image is fully dark or black

A fully dark or black image means the iris is closed too far and not enough light is reaching the sensor. When the Open Iris button does nothing, the Iris Type in FinishLynx usually doesn't match the lens, so FinishLynx can't open the iris. Check the Iris Type first.

How to fix it

Match the Iris Type to your lens

  1. Read the lens model printed on the side of the lens
    • A lens with no cable coming out of it is a manual lens: skip to the next section
  2. Open Camera Settings: select the camera in the Hardware Control window and click the blue "i" icon, or double-click the camera name
  3. On the Setup tab, near the bottom, set Iris Type to match the lens
    • 2.8-10mm lens (common on Vision and Vision PRO): P-Iris
    • 8-48mm lens (common on Vision): Normal
    • 12.5-75mm lens (common on Vision PRO): Normal
  4. Click OK

Open the iris

  1. Remote iris lens: in the Hardware Control window, click Open Iris until the image brightens
  2. Or let FinishLynx manage it: on the Camera Settings | Parameters tab set Gain Method to AGC and check Auto Iris, and FinishLynx opens the iris to suit the light
  3. Manual iris lens: open the iris with the iris ring on the lens itself until the image brightens

If it brightens, then goes dark again on its own

  1. Look at the Auto Iris icon in the image toolbar. FinishLynx switches Auto Iris off after several attempts that don't bring the gain back into range, and the iris stays where it was
  2. Click the icon to turn Auto Iris back on. There is no need to restart FinishLynx
    • If the icon isn't shown, turn on the Iris Control icons under the File | Options | Image tab

Check these

  • The lens cap is off
  • The remote lens cable (the black cable with the 9-pin connector) is plugged into the Remote port on the back of the camera, or into the Remote Positioner
  • The AGC Brightness value (Camera Settings | Parameters tab) hasn't been set very low. Raising it lightens the image
  • On older F-mount cameras with a Through The Lens Viewer, the viewer mirror is in the correct position
  • If Camera Settings doesn't have these options, your FinishLynx is too old to have them (version 10.10, for example). Install the current version from the Software page

If the iris controls still don't respond, see Can't control remote iris. If the image only gets dark as the sun goes down, see Too dark at dusk or under lights.

For an IdentiLynx or VeriLynx camera, see Black image when capturing.

The Gain Control Tools page of the Online Manual covers Auto Iris.