Starting camera settings

These are recommended starting values for outdoor track and field, all in Camera Settings. Set them for each camera once it is aligned, then fine-tune from test captures, because conditions at every venue are different.

The manual's Gain Control Tools page explains each gain setting, and the Camera Settings tutorial video walks through the dialog.

How to fix it

Gain and exposure (Parameters tab)

  1. Gain Method: AGC. Outdoors, AGC lets FinishLynx adjust the gain as the light changes
  2. Brightness: 60-80 for a white finish line such as a track; 20-40 for a dark finish line such as the turf of a horse track
  3. Frequency: 10
  4. Maximum Gain: 150 for most conditions; up to 250 in extreme low light
  5. Auto Iris: on, when a remote-control lens is connected to the camera back or through a Remote Positioner

Iris Type (Setup tab)

  • 2.8-10mm lens: P-Iris
  • 8-48mm lens: Normal
  • 12.5-75mm lens: Normal

Frame rate and height

  • For track sprints, a good rule of thumb is a frame rate at least 1.5 times the frame height, for example a rate of 1000 with a height of 640
  • Faster events need a higher frame rate, and a higher frame rate needs more light
  • For values by sport and camera model, see the Suggested Values of Rate, Height and Mode page in the Online Manual

Check these

  • Manual lens (no remote iris): set the iris so the gain sits in the lower third of its range, around 40. If the gain is near 150, open the iris; if it's near 0, close it
  • Manual gain: use it only if AGC doesn't give the result you want. Start at 40, then open or close the iris to adjust the exposure
  • Gamma and Black Level (Setup tab): the defaults are 0.70 and 0. If images look off, check they haven't been changed. Raise Black Level only in small steps (2-5) in low light when the darks look greenish and highlights bloom; the maximum is 20
  • IdentiLynx SR, SR-2 and HRS: the Brightness default is 60
  • Set these after the camera is aligned, in the order given in Align the camera on the finish line

Night, stadium lights or sun in the lens

  • Dusk or under lights: keep AGC with Auto Iris on, raise Brightness, let Maximum Gain go up to 250 if you must, and only then lower the frame rate a little. Full steps: Too dark at dusk or under lights
  • Sun straight into the lens: a filter won't fix it, so set the camera up with the sun behind it where you can. If the image is washed out with the gain reading 70 to 90, lower Brightness in steps of 5. See Glare from the sun
  • The image goes dark again by itself after you brighten it: with AGC and Auto Iris on, FinishLynx keeps moving the gain and iris to hold the Brightness target, so an iris change made by hand is undone. Change Brightness instead, or switch to Manual gain if AGC won't give the result you want

Good to know

Gain is best kept roughly between 20 and 60. Much higher gain brightens the image but adds noise, see Grainy or noisy image.