Grainy or noisy image
A grainy or noisy image most often means the camera is adding a lot of gain to make up for too little light. High gain brightens the image but adds noise, so the fix is to give the camera more light rather than more gain.
How to fix it
Check the gain
- In the Hardware Control window, look at the camera's Gain field. With AGC it shows the current gain followed by the Brightness in parentheses
- Gain is best kept roughly between 20 and 60. Values well above that are the likely source of the grain
Let in more light instead of gain
- Remote iris lens: turn on Auto Iris (Camera Settings | Parameters tab) so FinishLynx opens or closes the iris to keep the gain in range
- Manual iris lens: open the iris until the gain sits in the lower third of its range, around 40
- Check the AGC Brightness isn't set higher than the finish line needs. A higher Brightness makes AGC add more gain; 60-80 suits a white finish line
- In poor light, add light at the finish line or lower the frame rate slightly: see Too dark at dusk or under lights
Check these
- Black Level (Camera Settings | Setup tab, on cameras that have it, such as the Vision PRO): the default is 0. Raise it only in small steps (2-5) in low light; set too high, it adds a pinkish cast and upsets AGC
- Pixel Mode (Parameters tab): the Zoom settings raise resolution but lower the signal-to-noise ratio; the Wide settings have the best signal-to-noise ratio
- LuxBoost on Vision-series cameras is most useful once the gain is above 150 and the image gets noisy
- Focus: set the focus with the iris as open as possible (uncheck Auto Iris while you focus if needed), then turn Auto Iris back on. If the image is soft rather than speckled, see Image is blurry and can't focus
- IdentiLynx SR or HRS still grainy after focusing: the lens may have been knocked out of place. See Image is blurry and can't focus
The Gain Control Tools page of the Online Manual explains gain, AGC and LuxBoost.