Wired start not working
If FinishLynx gets no start when the gun fires or when you tap the sensor, these checks tell you whether the sensor, the cable or the camera settings are at fault. Set FinishLynx to expect the sensor first, then isolate the hardware.
How to fix it
Set FinishLynx to expect the sensor
- Open Camera Settings | Inputs tab and set the start sensor to match yours: Closed for a normally closed sensor (the standard white one, and the most common type), Open for a normally open sensor or the Lynx Electronic Start System
- The label on the side of the sensor says whether it is normally closed or normally open
- If you don't use RadioLynx, set Port on the RadioLynx tab to Off, so FinishLynx doesn't try to arm it
- Look at the red light on the side of the start sensor. With a normally closed sensor it should be on all the time
- If it only comes on while an event is armed, the Light setting on the Inputs tab is On When Armed rather than Always On
- Test it: with an event open, tap the sensor sharply on your palm or blow into it. FinishLynx should receive a start
Find which part is at fault
- Bypass the 500-foot start cable: connect the start sensor directly to the purple connection box, or to the DB15-XLR cable coming off the camera. If this works, the 500-foot start cable is the problem
- If that doesn't work, do the paper clip test: put a paper clip into holes 1 and 3 on the end of the DB15-XLR cable, or on the start port on the connection box. Inserting and removing it should trigger a start
- A start here means the camera and its cable are fine, so the start cable or the sensor is at fault. Bypass the long cable (step 1) to tell which
- No start here: go back to the Inputs tab settings above
- For a quick way to tell the sensor from the long start cable, see Two-minute sensor or cable test
No connection box (and every FinishLynx LITE setup)
- You don't need one. Plug the DB15-to-XLR cable into the back of the camera, connect the start cable to it, and put the start sensor on the far end
- Run the paper clip test on the end of the DB15-XLR cable
To recover a race that ran without a start, see Recover a race after a missed start. The Wired Starts page of the manual has the settings.