No reaction time for a lane or sensor not seen

When one lane reports nothing, or the starter hears repeated beeps in the headset, the Command Center can't talk to that Block Sensor. The usual causes are a wrong or duplicated lane number, a cable not seated in a wired system, or a sensor and Command Center set to different network types.

How to fix it

Check the sensors and cables

  1. Confirm every Block Sensor and the Command Center are on and the LCD is readable on each
  2. On each Block Sensor, check the lane number in the upper left corner of the LCD
    • To change it: press Menu, scroll to Main Menu | System, press Menu, scroll to System Menu | Lane Number, press Menu, pick the lane with the up arrow, then press Menu to return to ReacTime | Ready to Start
  3. On each Block Sensor, open System Menu | Network Type the same way and make sure it matches the Command Center (Wired or Wireless)
    • The Command Center ships set to Wired
  4. Wired system: check the False Start Cable runs from sensor to sensor and the Command Center Cable runs from the Lane 1 sensor to the Command Center
  5. Wireless system: turn off (or put on the charger) any spare Block Sensors you aren't using
    • A spare sensor that is on nearby with the same lane number as one in use confuses the system, for example two lane sixes
  6. On the Command Center, set the number of lanes in use
    • Press Menu, scroll to Main Menu | System, press Menu to reach System Menu | Number of Lanes, press Menu and choose the number. The count shows in the upper left of the Command Center LCD

If the start went through but times or traces are missing

  • After the Set beep, the gun must fire within three seconds. If the rapid warning beeps sound first and the gun is then fired, reaction times are recorded but no traces are stored. To avoid this, press Start again to go back to Standby and repeat the Set phase
  • Reaction times show on each sensor's LCD right after the gun and disappear as soon as the Start key is pressed again. Read them, print them, or add them to the Championship Software before the next start
  • Armed In Ready | Yes on the Command Center still captures data if the operator forgets to put the system in Set (the data will have no set time)

If a sensor still shows the training screens, see Training system vs Championship system. The menu paths are in Configure the Block Sensors and Operate the Competition, and the whole setup is in the ReacTime Championship Setup QSG.

Good to know

Repeated beeps in the headset mean a Block Sensor or cable connection failure. Three strong beeps mean a false start, not a fault.

Related resources