Lynx 360 Display

Set it up

1. Assemble the frame and panels. The Lynx 360 Display basic setup video shows the build.
2. Wire power and signal with the electrical setup guide for your build: Lynx 360 (single) or Lynx 360 (double).
3. In ResulTV go to File | Options… | General and set Profile to Video-360 (single) for a one-tier build or Video-360 (double) for a two-tier build. Click OK, then exit and restart ResulTV.
4. Set up the scoreboard output in FinishLynx or FieldLynx with the settings in the 360 Display QSG. The same steps are in Desktop shows but no results.

What you need

• A Windows computer running FinishLynx 13.00 or later (the Network ComPort is built in) or FieldLynx with the Scoreboard plug-in.
• ResulTV. The 360 always uses ResulTV to draw the picture.
• Power for the whole display: about 15 amps at full brightness for a single, about 30 amps for a double. See Brightness and power requirements.

If it is built and wired but not behaving

• Nothing on the display: Whole display is blank
• Some panels dark or the picture out of order: Some panels dark or picture out of order
• Too bright or too dim: Brightness and power requirements
• Shows the desktop but no results: Desktop shows but no results