Command Center not found by the PC or drops the connection

The ReacTime software talks to the Command Center (or a Training Block Sensor) over the ReacTime Serial Cable and one COM port.

A timeout, a unit that isn't found, a connection that drops during a meet, or a Command Center that is slow to boot almost always comes from that cable, the COM port selection, or a USB-to-serial adapter.

How to fix it

Check the cable and COM port

  1. Connect the ReacTime Serial Cable between the Command Center's Serial Cable input and the computer, and make sure the unit is turned on
  2. Reseat both ends of the serial cable
  3. If you use a USB-to-serial adapter, check its driver is installed and note the COM number Windows gave it
  4. In the ReacTime Championship Software, click Hardware | Options, open the Serial tab and pick that COM port from Serial Port. Click OK
    • In the Training Software the list is called Serial Input
  5. On the Results tab, set Default Number of Lanes to the number of Block Sensors connected to the Command Center
  6. If you see "Serial Connection Receive Timeout" while downloading, check the serial connection and that the unit is on, then select the trial again and click Download
  7. After a race, click Add Reaction Times to this Event (or Results | Add Reaction Times) to pull the most recent race into the open event

If the software installs but won't download

  • The software needs a serial number to download and analyze trials. Without one it runs in demo mode, which can only update firmware and language files
  • To check the firmware version the software sees, click Help | About. Updating firmware uses Hardware | Update Firmware with the unit turned off and unplugged from power, then the bs.img (Block Sensor) or cc.img (Command Center) file

Battery-powered units also drain faster while trials are being uploaded: see Sensor battery drains or won't charge. The current software is on the Software page.

The steps are in Configure ReacTime Championship Software, Work with Trials in the Software and Update Firmware.