Error messages and codes
Find the message you see below and open its entry. If your message isn't listed, send it to us with the button at the end.
How to fix it
Camera boot errors
- Error 129: Error 129
- Error 201: Error 201
- Error 202 on an EtherLynx camera: Error 202
- Error 202 on an IdentiLynx or VeriLynx camera (for example, after loading to 32%): Error booting camera
- Any other boot error code: Other code
- "Error Aligning a Camera": see the FAQ, under Common error messages
Starts and capture
- "All start sensors failed to arm": "All start sensors failed to arm"
- "Error arming event": see the FAQ, under Common error messages
- "Spacebar toggles capture": Spacebar toggles capture
- "Capture Button Serial Port Unavailable": see the FAQ, under Common error messages
- "Error capturing" with "No cameras enabled": "No cameras enabled" when capturing
Start lists, results and saving
- "Could not find .evt file", or a blank list after Load Schedule: Start lists not found
- "This result is not in the start list": Result is not in the start list
- Error 3002, "Error writing .LIF file": Error writing .LIF file
- "Error accessing a file" when saving a race, or when advancing to the next event: open Event | Options and check the Event Directory. If it points to a mapped network drive or a folder on another computer, set it to a local folder on the FinishLynx computer, then save again.
- Every save writes the race's large image files there, and a network path that drops or slows down can make the save fail. A local folder, including one on a second partition of the same drive, is fine.
- If another computer or the meet software needs the files, share that local folder from the FinishLynx computer rather than saving across the network.
- If the error keeps coming back with a local Event Directory, use the button below.
- "Error reading from file" when opening a saved event: check Help | About on the computer that saved the event and on the one opening it.
- If the versions differ, open the events on a computer running the version that saved them, then save them again so the results are written. If the versions match, or the events still won't open, use the button below.
- "Results file for event #, heat/chute 1 not found" in HyTek Meet Manager: Start lists not found
- "No image found" on the evaluate computer: Capture-and-read FinishLynx setup
Installing and starting
- "Error Opening File for Writing" during an update: Installer errors
- "Waiting for printer connection" or a printer warning: Slow start or printer warning
- Missing DLL errors or Error 1904 in LynxPad: Won't launch, missing DLL
- Username and password prompt when printing in LynxPad: Prompted for username/password
- "Windows cannot access \\PC-NAME" when mapping a shared folder: Multi-computer networking
Talk to Lynx Support
Tell the team what you’re seeing and what you’ve already tried. They’ll follow up by email or phone.